Tutorial by nateiskewl from UPSB.
Requested by Enzo.
Name of Pen Modification: kUzu's G3 Mod
Center of Gravity: center
Length in Centimeters: approx. 20 cm
Weight in relative terms: similar to Dr. KT
Style: Single-sided non-retractable
Estimated cost: $25
Parts Needed:
-Plastic tipped Pilot G3 body [1], A
-Zebra Hyper Jell Cap [1], B
-a grip similar to the Hyper Jell's (I used Jimnie grip) [1 cm], C
-Uniball Signo dimpled grip version grip [1], D
-Zebra Hyper Jell grip [1], E
-Uniball Signo Knock grip (w/ cut design if wanted) [1], F
-Plastic tipped Pilot G3 tip [1], G
-Uniball Signo dimpled grip version tip [2], H
-Pilot Hi-tec C tip [2], I
-Pentel Hybrid Gel Grip tip [1] (not included in picture)
-Anyball/Profile grip [approx 3 sections] (not included in picture)
Tutorial:
1. Strip the G3 so you only have the barrel.
2. File down the 8 cube-shaped nubs on the G3, as well as the raised area next to where the tip would be attached.
3. Cut approx. 1cm of the Hyper Jell grip and slide it onto the G3's grip area.
4. Cut approx. 1cm of the unkown grip (I recommend using Jimnie or Hyper Jell) and slide it next to the Hyper Jell grip.
5. Attach a Hi Tec C tip to the G3 plastic tip, then attach a Signo tip to the Hi Tec C tip. Screw the G3 tip onto the G3's threads. You should have three pen tips on the front of the Pilot G3.
6. Slide the Signo grip over the three tips.
7. Cut a design into your Signo Knock grip, then put it on top of all the other grips at the front of the G3.
8. Put a few sections of Anyball/Profile in front of the cut grip. The front of the pen is completed!!! Good job.
9. Take the clip off of the Hyper Jell cap.
10. Put the other Signo tip into the Hyper Jell cap like you would while making an Ayatori Mod.
11. Put the other Hi Tec C tip and the HGG tip into the rest of the Hyper Jell grip. Put the grip into the Hyper Jell cap (HGG tip first).
12. Wrap some black tape around the back of the G3, stick an insert in and you're finished!
Completed pen:
Any questions?